Mcintosh MA Integrated Amplifier
Mcintosh MA Integrated Amplifier 220V Minimum sine wave continuous average power output per channel all channels operating is: 200 watts into 2 ohm load 200 watts into 4 ohm 200 watts into 8 ohm load Rated Power Band 20Hz to Hz Total Harmonic Distortion Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output Dynamic Headroom 2.4dB Frequency Response +0, -0.5dB from 20Hz to Hz +0, -3dB from 10Hz to Hz Sensitivity Phono, 2.5mV for 2.5V rated output (0.5mV IHF) High Level, 250mV for 2.5V rated output (50mV IHF) Power Amplifier Input, 2.5V for rated output Signal To Noise Ratio (A Weighted) 90dB (84dB IHF) below 10mV input, Phono Input 100dB (90dB IHF) below rated output, High Level 110dB below rated output, Power Amplifier Intermodulation Distortion Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to Hz, with all channels operating is: % for 2, 4 or 8 ohm loads Input Impedance Phono, 47K ohms, 65pF High Level, 22K ohms Maximum Input Signal Phono, 90mV High Level, 8V Preamplifier Maximum Voltage Output Phono, 8V at tape output High Level, 8V at tape output Main Out, 8V at preamp output Voltage Gain High Level to Tape: 0dB High Level to Main: 20dB Wide Band Damping Factor Greater than 40 Power Requirements 100 Volts, Hz at 5.2 Amps 110 Volts, Hz at 4.8 Amps 120 Volts, Hz at 4.4 Amps 220 Volts, Hz at 2.45 Amps 230 Volts, Hz at 2.35 Amps 240 Volts, Hz at 2.25 Amps Note: Refer to the rear panel of the MA for the correct voltage. Overall Dimensions Front Panel: inches (cm) wide, 7-1/8 inches (cm) high. Depth behind front mounting panel is inches (cm). Clearance required in front of the Front Panel is 1 inch (2.54cm) for knobs. This Amp is in excellent, like-new condition Read More