They are in excellent working condition. They have some marks but with no effect on performance.
The speakers are in excellent working condition. They have some marks, but with no effect on the performance. They were fully serviced in August (invoice available) and have since been securely packaged in their box. I am selling because they are no longer being used and I need to reduce my storage space. Description: The S7 is a self-powered, 2-way active monitor. Its integral electronics make it a compact yet powerful choice providing a combined output of 190 W for each monitor. It is fully magnetically shielded, so it can be used in close proximity to CRT monitors or TVs. The S7 is a finely tuned reflex port design. Extensive work has gone into the amplifier and active cross over, employing world leaders in amplifier design. This combination has produced a product that boasts excellent sonic accuracy with un-hyped bass exactness. EQ a jazz double bass or house music kick drum with ease. The S7 is suited to a wide variety of applications. Typical applications include near-field monitoring for recording/mixing, programming, post production suites, broadcast and surround sound. The high power output enables the monitors to be used where high monitoring levels are required such as location work. The compact size allows for ease of placement of three or more units for LCR and multi-channel applications. Although the bandwidth of the S7 is adequate for most situations, the low end performance can be further extended by combining it with an SB series sub bass. The two products make an ideal combination and extend the frequency response down to 20 Hz. Specifications: Size (WxHxD) Dimensions: 244(w) x 347(h) x 302(d) mm Weight 11.7 kgs Drivers Bass cone - 1 x 165 mm (6 Ā½ ") High Frequency soft dome - 1 x 28 mm (1 ?") Maximum SPL 115 dB (c) continuous pink noise @ 1 m (121 dB (c) per pair RMS music) Frequency Response 65 Hz-22 kHz Ā± 2 dB Input Connector XLR and Ā¼ inch Jack combo socket Impedance 10k electronically balanced with RF filters Wiring Pin 1 ground Sleeve Pin 2 hot Tip Pin 3 cold Ring Sensitivity -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear Filters - Subsonic -3dB @ 30 Hz, 24dB/oct / Ultrasonic -3dB @ 75kHz, 4dB/oct Crossover 1k19 LF EQ - Hz HF EQ +/- 2dB @ 10 kHz LF output power > 120W RMS HF output power > 70W RMS T.H.D. Hum + Noise > -100 dB referred to clip Power on Front mounted green LED indicates power applied. Clip Red LED 2 dB before amplifier clip. * NOTE 1: The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30ĀŗC. Power requirements: Voltage Set by internal plugs: nominal 115V or 230V @ Hz AC 230V setting: min 160V; restricted output power: max 255V 115V setting: min 80V; restricted output power: max 127V Consumption Quiescent 18W Typical use 75W (average music) Max 140W (average music) Note 0 dBu = 775 mV into open circuit Ad ID: Delivery Services Consumer Credit