Sky wireless connector mini Amstrad DRX890 or DRX895) are compatibleI.
Setting up On Demand with your On Demand Connector MINI Turn off your Sky+HD box by switching it off at the mains. Plug in the large end of the black USB cable into the USB port on the back of your Sky+HD box. The smaller end goes into the back of your On Demand Connector MINI. Turn your Sky+HD box on at the mains. Wait two minutes before switching it back on from standby mode by pressing the sky button on your Sky remote and then select any channel. Connect to your broadband router If your broadband router has a WPS (Wi-Fi Protected Setup) button: Press and hold the WPS button on your broadband router for two seconds. Within one minute press the WPS button on the On Demand Connector MINI and hold for two seconds. The wireless light on the front of your Sky+HD box will flash amber while the box attempts to establish an internet connection. It will turn solid amber when the connection has been successful. If your broadband router doesn’t have a WPS button, or you don’t want to connect by WPS, then you can connect by entering the Wi-Fi password: Press services, 0, then 5 on your Sky remote. This will take you to the Network tab. You’ll see a choice of three options for connecting your Sky+HD box. Choose Connect with Passwordusing your Sky remote and press select. Choose your wireless network (SSID) from the list and press select. If you're not sure what your wireless network is called, this can usually be found on the back or base of the broadband router, next to the password. Enter the password using your remote control then press selectto connect. Remember that passwords are case-sensitive: you can cycle through uppercase letters, numbers and lowercase letters through repeated pressing of the number buttons on your Sky remote. Special characters can be entered by repeated pressing of the 0 button. If you prefer to connect your broadband router using a WPS PIN, press services, 0, then 5 to show the Network tab and select Connect with WPS PIN. Follow the onscreen instructions. To check that setup was successful, press the tv guide button on your Sky remote, then the red buttonto enter the On Demand menu. If each programme is shown with its own picture then the setup is complete and you're now ready to use On Demand.  Ad ID: Delivery Service Consumer Credit