They are in excellent working condition. They have some marks but with no effect on performance.
The speakers are in excellent working condition. ong>Theyong> ong>haveong> some marks, but ong>withong> no effect on the performance. ong>Theyong> were fully serviced in August (invoice available) and ong>haveong> since been securely packaged in their box. I am selling because ong>theyong> are no longer being used and I need to reduce my storage space. Description: The S7 is a self-powered, 2-way active monitor. Its integral electronics make it a compact yet powerful choice providing a combined output of 190 W for each monitor. It is fully magnetically shielded, so it can be used in close proximity to CRT monitors or TVs. The S7 is a finely tuned reflex port design. Extensive work has gone into the amplifier and active cross over, employing world leaders in amplifier design. This combination has produced a product that boasts excellent sonic accuracy ong>withong> un-hyped bass exactness. EQ a jazz double bass or house music kick drum ong>withong> ease. The S7 is suited to a wide variety of applications. Typical applications include near-field monitoring for recording/mixing, programming, post production suites, broadcast and surround sound. The high power output enables the monitors to be used where high monitoring levels are required such as location work. The compact ong>sizeong> allows for ease of placement of three or more units for LCR and multi-channel applications. Although the bandwidth of the S7 is adequate for most situations, the low end performance can be further extended by combining it ong>withong> an SB series sub bass. The two products make an ideal combination and extend the frequency response down to 20 Hz. Specifications: ong>Sizeong> (WxHxD) Dimensions: 244(w) x 347(h) x 302(d) mm Weight 11.7 kgs Drivers Bass cone - 1 x 165 mm (6 ½ ") High Frequency soft dome - 1 x 28 mm (1 ?") Maximum SPL 115 dB (c) continuous pink noise @ 1 m (121 dB (c) per ong>pairong> RMS music) Frequency Response 65 Hz-22 kHz ± 2 dB Input Connector XLR and ¼ inch Jack combo socket Impedance 10k electronically balanced ong>withong> RF filters Wiring Pin 1 ground Sleeve Pin 2 hot Tip Pin 3 cold Ring Sensitivity -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear Filters - Subsonic -3dB @ 30 Hz, 24dB/oct / Ultrasonic -3dB @ 75kHz, 4dB/oct Crossover 1k19 LF EQ - Hz HF EQ +/- 2dB @ 10 kHz LF output power > 120W RMS HF output power > 70W RMS T.H.D. Hum + Noise > -100 dB referred to clip Power on Front mounted green LED indicates power applied. Clip Red LED 2 dB before amplifier clip. * NOTE 1: The continuous rating is for a period not exceeding 5 minutes ong>withong> unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30ºC. Power requirements: Voltage Set by internal plugs: nominal 115V or 230V @ Hz AC 230V setting: min 160V; restricted output power: max 255V 115V setting: min 80V; restricted output power: max 127V Consumption Quiescent 18W Typical use 75W (average music) Max 140W (average music) Note 0 dBu = 775 mV into open circuit Ad ID: Delivery Services Consumer Credit