Bronze Cutless Bearing Housing for 25mm diam Bearing & Shaft, also Inboard Bearing Housing Available
This is a used cutless bearing housing to take a 25mm diameter bearing and propellor-shaft. It is made of cast bronze, and takes a 50mm long bearing, which was rather short for our 1 metre long prop shaft, so we have changed to a 100mm long housing and bearing, which cost over £200. As it is the removable bearing that takes all the wear, it is is fine condition. It will be suitable for a short prop shaft, or a situation where there is not enough room for a longer bearing housing such as inside a rudder aperture on a long-keeler. The inboard end of the casting is threaded for attaching to the stern tube, and the threads are 16 TPinch, or 6 TPcm, and inch diameter on a 1.5 inch diameter tube. The two anti-twist bolt holes are at 4.3 inch, 110mm, centres. A suitable new section of bearing is available at no extra charge. Asking £65 ono I also have available the bearing housing from the inboard end of the same stern tube, with the same thread. Would sell sperately for £65 ono, or together for £120 ono. Buyer collects or I could post it at cost. Ad ID: Delivery Service Consumer Credit