AMAHA PS AMP (350w)
Second hand good working order. COLLECTION ONLY. £350 NEW! No silly offers! * * Specs: Output Power - 1kHz, THD+N=1% 8 Ohms Stereo: 275W + 275W - 1kHz, THD+N=1% 4 Ohms Stereo: 390W + 390W - 1kHz, THD+N=1% 8 Ohms Bridge: 780W - 20Hz-20kHz, THD+N=1% 8 Ohms Stereo: 250W + 250W - 20Hz-20kHz, THD+N=1% 4 Ohms Stereo: 310W + 310W - 20Hz-20kHz, THD+N=1% 8 Ohms Bridge: 620W - 1kHz, 20mS nonclip 2 Ohms Stereo: 650W + 650W - 1kHz, 20mS nonclip 4 Ohms Bridge: W - Power Bandwidth (half power): 10Hz-40kHz (THD+N=0.5%) - THD+N (20Hz - 20kHz, half power): Maximum 0.1% - Intermodulation Distortion (60Hz: 7kHz, 4:1, half power: Maximum 0.1% - Frequency Response: 0dB, +0.5dB, - 1dB f=20Hz-50kHz - Channel Separation: Minimum 70dB 1kHz - Residual noise (Att. min.): Maximum 70dB - S/N Ratio: 100 dB - Damping Factor: 200 max. - Sensitivity @8 Ohms +3dB - Voltage Gain (Att. max): 32.1dB - Input Impedance: 30kOhms balanced; 15kOhms unbalanced Controls - Front Panel: POWER switch (push on/push off) attenuator (31position) x 2 - Rear Panel: MODE switch (STEREO/BRIDGE/PARALLEL), FILTER switch (SUB WOOFER/LOW CUT/OFF) x 2, FREQ. CONTROL (25Hz-150Hz) x 2, YAMAHA SPEAKER PROCESSING switch (ON/OFF) Connectors - Input: XLR-3-31 type/ch, 1/4 in. - Output: SPEAKON, 5-way biding post, 1/4 in. phone/ch Indicators - POWER: x 1 (Green) - PROTECTION: x 1 (Red) - TEMP: x 1 (Red) heatsink temp 85 degrees - YS PROCESSING: x 1 (Yellow) - SIGNAL: x 2 (Green) - CLIP: x 2 (Red) Load Protection - POWER switch on/off mute - DC-fault power output cut Amplifier Protection - Thermal (heatsink temp 90 degrees C) - VI limiter - Limiter Circuit: Comp. THD 0.5% - Cooling: Dual variable-speed fan / Single variable-speed fan - Power Requirements: USA/120V 60Hz - Idle Power Consumption: 25W - 1/8 Power Consumption: 320W - Maximum Power Consumption (4 Ohms): W - Dimensions (W x H x D): in. x in. x in. - Weight: 26.5 lbs Ad ID: Delivery Service Consumer Credit