2 X Front bike wheel light. 128 LED, power switch dodgy. needs mending if possible, 26 inch wheel
These are my what are nice really bright programmable lights. Is a bit fiddly to get the light driver going so it shows up in control panel, device manager. When it is then the way to get what you want on it is fine. Pictures and words need to be going fast and the little circuit board switch that sets magnet orientation so light knows what is up has never worked, I just got rid of the preset things and started again on ready made shapes and patterns, not so fussy about up or down, just shapes. 1 is a year old and died. bought another just to get the battery box. did swap the lot but never really was any need to change light. that lasted 6 months from last October, November time. is the battery box. What lets these down is the red power switch on the battery box. They fail. hard work to get it to stay on and a sealed unit. might be able to cut around top with a little drimmel hand held tool. short out switch so it stays on. after 30 seconds light turns off and takes micro amps when just sitting there, with a 2.2Ah lithium cell that lasts about 14 hours this not a problem, just take battery out in summer and if going out at night pop it back in. 2 lights. 1 unused pack of tie wraps and magnet for front fork. Can't find one of the usb leads for programming but got 1. Front wheel is what I had it on, back covered with pannier bags so pointless anyway. look up yq bike light some come with a rubbish charger for cells. Would not use the bundled rubbish. Got a proper 4 channel charger with display. Front bike light, caving torch, handheld torches use these cells. Up to you what charger you want, but will need one. Anything with a mains lead on is better than the rubbish with flip out prongs and unfused adaptor to suit our wall sockets (say no more, never use that junk). Ad ID: Delivery Service Consumer Credit